The
Eaton Caska-Rol placer is simple and totally
maintenance free. Placer consists of a set of three
bars fabricated from heavy steel channel with a
durable powder-coat epoxy finish, assuring you of
years of trouble-free service. Each bar has two
10" rubber rollers to allow any size casket to
roll smoothly without drag. One bar comes with a
brake attachment to lock the casket into the desired
position during the ceremony. The Caska-Rol Placer
will fit on any device at settings from 31" to
41" distance between rails.
Three
Simple Steps to Operate the Caska-Rol Placer:
1.
To set up — On any lowering device set at any
width, lay the 3 Caska-Rol bars on the side rails.
The brake bar should be in front. The 3 bars can be
placed anywhere on the device, wherever they best
suit your type of service.
2.
To use — The casket is placed on the front
rollers, with the brake off, and then pushed along
until it rests in the proper position on all three
bars. Tighten the brake.
3.
To remove — At the conclusion of the service,
tighten the straps of the device and while one end
of the casket is raised up, remove two bars. Repeat
procedure at other end removing last bar. Casket is
then ready to be lowered.
|
